Owner’s manual
RSX-1056
Surround Sound Receiver
SURROUND SOUND RECEIVER RSX-1056
STANDBY
VOLUME
1
6
2
7
3
8
4
9
5
0
TUNING
BAND
CD
TUNER
TAPE1
VIDEO1
VIDEO2
VIDEO3
MUTE
VIDEO4
ZONE
VIDEO5
DOLBY
PLII/3ST
DTS
MULTI
INPUT
DIRECT
MONO
MEMORY
2CH
Neo
6
DSP
REC
Notice
Important Safety Instructions
WARNING: There are no user serviceable parts inside. Refer all servic-
The COMPUTER I/Oconnectionshould be handled by authorized person
only.
ing to qualified service personnel.
WARNING: To reduce the risk of fire or electric shock, do not expose the
unit to moisture or water. Do not allow foreign objects to get into the enclo-
sure. If the unit is exposed to moisture, or a foreign object gets into the
enclosure, immediately disconnect the power cord from the wall. Take the
unit to a qualified service person for inspection and necessary repairs.
FCC Information
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radi-
ate radio frequency energy and, if not installed and used in accordance
with the instruction, may cause harmful interference to radio communica-
tions.
Read all the instructions before connecting or operating the component.
Keep this manual so you can refer to these safety instructions.
Heed all warnings and safety information in these instructions and on the
product itself. Follow all operating instructions.
However, there is no guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
Clean the enclosure only with a dry cloth or a vacuum cleaner.
Do not use this unit near water.
You must allow a minimum 10 cm or 4 inches of unobstructed
clearance around the unit. Do not place the unit on a bed, sofa, rug,
or similar surface that could block the ventilation openings. If the unit is
placed in a bookcase or cabinet, there must be ventilation of the cabinet to
allow proper cooling.
•
•
•
Reorient or relocate the receiving antenna.(TV, radio, etc.)
Increase the separation between the equipment and receiver
Connect the equipment to an outlet on circuit different from that to which
the receiver is connected.
Keep the component away from radiators, heat registers, stoves, or any
other appliance that produces heat.
•
Consult the dealer or an experienced radio/TV technician for additional
help.
The unit must be connected to a power supply only of the type and voltage
specified on the rear panel. (USA: 115 V/60Hz, EC: 230V/50Hz)
Connect the component to the power outlet only with the supplied power
supply cable or an exact equivalent. Do not modify the supplied cable. Do
not A polarized plug has two blades, with one wider than the other. A
grounding plug has two blades plus a third grounding prong. These are
provided for your safety. Do not defeat grounding and/or polarization safety
provisions. If the supplied plug does not fit your outlet, please consult an
electrician for replacement of the obsolete outlet. Do not use extension cords.
Caution
This device complies with part 15 of the FCC Rules operation is subject to
the following to conditions: (1) This device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
The main plug of the power cordset is a disconnect device of the appara-
tus. In order to completely disconnect the apparatus from the supply mains,
the main plug of the power cordset should be unplugged from the mains
(AC) outlet. The stand-by LED indicator will not be lit up to show the power
cord is unplugged.
NOTE TO CATV SYSTEM INSTALLER: Call the CATV system or antenna
installer’s attention to Article 820-40 of the NEC. This provides guidelines
for proper grounding and, in particular, specifies that the cable ground
shall be connected to the grounding system of the building, as close to the
point of cable entry as practical. See installation diagram.
Do not route the power cord where it will be crushed, pinched, bent, ex-
posed to heat, or damaged in any way. Pay particular attention to the power
cord at the plug and where the cord exits the back of the unit.
NOTE: This equipment has been tested and found to comply with the lim-
its for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against interference
in a residential installation. This equipment generates and can radiate ra-
dio frequency energy and, if not installed and used in accordance with the
instructions, may cause interference to radio or TV communications. There
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause interference to radio or television reception,
which can be determined by turning the equipment off and on, try to cor-
rect the interference by one or more of the following measures:
The power cord should be unplugged from the wall outlet during a light-
ning storm or if the unit is to be left unused for a long period of time.
Use only accessories specified by the manufacturer.
Use only with a cart, stand, rack, bracket or shelf system recommended by
Rotel. Use caution when moving the unit in a stand or rack to avoid injury
from a tip-over.
Immediately stop using the component and have it inspected and/or ser-
viced by a qualified service agency if:
•
•
•
•
Reorient or relocate the receiving antenna.
Increase the separation between the unit and the television tuner.
Connect the unit to an AC power outlet on a different electrical circuit.
Consult your authorized Rotel retailer for assistance.
• The power supply cord or plug has been damaged.
• Objects have fallen or liquid has been spilled into the unit.
• The unit has been exposed to rain.
• The unit shows signs of improper operation
• The unit has been dropped or damaged in any way
RSX-1056 Surround Sound Receiver
4
1: Controls and Connections
1
2
3
4
5
6
SURROUND SOUND RECEIVER RSX-1056
STANDBY
VOLUME
1
6
2
7
3
8
4
9
5
0
TUNING
BAND
CD
TUNER
TAPE1
DTS
VIDEO1
VIDEO2
VIDEO3
MUTE
VIDEO4
ZONE
VIDEO5
DOLBY
PLII/3ST
MULTI
INPUT
DIRECT
MONO
MEMORY
2CH
Neo
6
DSP
REC
7
8
9
10
23
11
12
13 14 15 16
17
18
19
20
21 22
24
25
26
27
ANTENNA
SPEAKERS
SURROUND
LEFT
CENTER
FRONT/CB/ZONE
LEFT/1
Manufactured under license from Digital
Theater Systems, Inc. US Pat. No. 5,451,942,
5,956674, 5,974,380, 5,978,762, and other
world-wide patents issued and pending.
"DTS" and "DTS Digital Surround" are
registered trademarks of Digital Theater
Systems, Inc. Copyright 1996, 2000 Digital
Theater Systems, Inc. All rights reserved.
FRONT
FRONT
L
REAR
L
CB
1
CENTER
FRONT
L
REAR
L
CB
1
CENTER
CENTER
1
SUB
SUB
1
2
DIGITAL INPUT
1
DIGITAL OUT
OPTICAL
COAXIAL
2
COAXIAL OPTICAL
R
REAR
1
R
CB
2
SUB
1
FRONT
R
REAR
R
CB
2
2
1
Y
2
3
COMPUTER I/O
REM IN
IR OUT
12V TRIG OUT
2
ZONE
EXT
2
ZONE
RIGHT
RIGHT/2
SOFTWARE
UPGRADABLE
POWER
ZONE
OUT
COMPONENT VIDEO IN
CD
TAPE
VIDEO IN
3
VIDEO OUT
2
PB
PR
Y
PB
PR
IN
OUT
1
2
4
5
1
3
ON
1
3
L
SURROUND SOUND
RECEIVER
MODEL NO. : RSX-1056
POWER CONSUMPTION:
450 WATTS
MON
OUT
2
R
OFF
S-VIDEO IN
3
S-VIDEO OUT
2
COMPOSITE IN
3
COMPOSITE OUT
ZONE
OUT
MON
OUT
MON
OUT
CAUTION
1
2
4
5
1
3
1
2
4
5
1
2
3
RISK OF ELECTRIC SHOCK
DO NOT OPEN
Manufactured under license from Dolby
Laboratories. "Dolby", "Pro Logic", "Surround
EX", and the double-D symbol are trademarks
of Dolby Laboraties Licensing Corporation.
32 34
36
28
29
30
31
33
35
37
38 39
40 41
42
43
English
5
2: RR-1050 Remote
CLONE REPT TRANSMITTER LOADING RECEIVER
EDIT LEARN
WAITING
CLONE REPT TRANSMITTER LOADING RECEIVER
AUD
CD
TUN
TAPE
EXT
V5
N
DEVICE / INPUT
A
B
V1
1
V2
V3
3
V4
POWER
EDIT LEARN
WAITING
ON
OFF
2
5
8
0
O
P
4
6
CH
VOL
Q
7
9
MACRO
M
MUTE
MENU
+10
X
R
S
GUIDE
FRQ DIRECT
C
C
M
UP
ENT
DWN
CTR
OSD
D
TUNE
PRESET
E
F
+
-
T
FM MONO BAND
SEARCH –
SEARCH +
G
S
R
H
SUB
SUR
CD
DISC 1
I
J
K
U
V
DISC 2
DYN
DISC 3
REC
DISC 4
ZONE
DISC 5
SUR+
EQ
2CH
PL C
PL M
5CH
7CH
X
PROG
RANDOM REPEAT
DISC-
DISC+
Y
Z
DISPLAY
DISP
AUDIO
TAPE2
ANGLE
PHONO
SBTITLE
TONE
ZOOM
D-SLT
RESUME REPEAT
A -B
P-TUN
GOTO
TP
SLOW
TA
AA
SCAN
PTY
L
INPUT 1
INPUT 2
INPUT 3
TV/VCR
RECORD
BB
DVD
POWER
/ CLONE
EDIT
LEARN
M
CLEAR
LANG
PRELOAD RESET
PAGE 1/2
CC
|